Rubber Dock Bumpers

These economical dock bumpers are the very best choice for most loading dock applications.

• Nylon reinforced rubber truck tire material provides protection both for truck beds and for dock surfaces.
• Will not chip or dish out on impact like molded products.
• 4-1/2” or 6” depths absorb most of the impact and provides the correct spacing between dock and truck for best access.
• Rubber laminated between ¼” carbon steel angle and held in place by two ¾” rods.
• Economical
• Can be welded or anchored with lag bolts or both for best application.
• Several sizes to accommodate most applications.

Rubber Dock Bumpers can also be used anywhere in the plant to keep machinery from damaging property or equipment.

Made from nylon reinforced rubber truck tires, the dock bumpers are cut into exact size and captured between two 3”x3”x1/4” structural steel angle. The rubber pads are compressed and the angles are attached with two ¾” bolts. This makes for a very rugged and dense block that can absorb shock, not allowing that shock to damage the dock face or truck bed.

Trucks not only impact the dock when they back into position but also scrub up and down as the loading process continues. Properly installed these dock bumpers will always present the “grain” (laminated pieces) vertical thereby allowing the up and down movement without catching. It is sometimes necessary to accommodate a wide variety of equipment and a pattern of these dock bumpers can do that.

Anchors not included. Listed width is to center of mounting hole.

Black Rugged Dock Bumper