Products

Railboard Worksheet

This form must be submitted complete with all orders for rail dockboards.
Bluff products are site specific products and should only be used at site
for which they are designed.

Order Request for quote

(Complete the form below and click the submit button below.)

Identify railcar type(s) encountered at this site:
box car	refrigerated car
all door car	flat car
plug door car

Provide a minimum of two X dimension measurements, from the inside of the rail to the dock face (excluding any projections,) with each measurement taken 20' away form the center of the dockboard position. Provide dimensions for each location in which the board will be used. If the application is a long, open dock, provide X dimensions at 20' increments along the dock.	X1* X2* X3
	X4 X5 X6
	X7 X8 X9
	X10

Provide a minimum of one Y dimension measurement, from the top of the rail to the top of the dock utilizing a line level and string, for each dockboard location.		Y1* Y2 Y3
		Y4 Y5 Y6
		Y7 Y8 Y9
		Y10

* Identify the narrowest car door to be encountered at this site (range form 6-20 feet).
* Will cargo loading/unloading practices prevent a minimum of 8" of railboard lip from resting on the railcar floor?	Yes No
* Identify the types of equipment / attachments used to travel across the railboard. i.e.- paper roll clamp.
* Identify the load capacity of the equipment used for this application.
* Is the face of the dock square?	Yes No
* Identify any dock projections within 10"of the top of the dock surface.
* Provide width of the narrowest opening that the dockboard must pass through.
* Provide desired dockboard width. The dockboard should be 2 to 4 inches less than the minimum car door width encountered at this site.
* Provide desired dockboard flair width. Flair, if desired, provides a dockside lip of greater width than the carside lip.

* Site Location:
* Date Submitted:	xx/xx/yyyy
* Salesman:
* Dealer:
* Telephone:
* City/State:
* E-mail:
* Fax:
Remarks: